MIJING ZH01 Face ID Integrated IC Chip for iPhone 15 Series

Key features

• Face ID integrated IC chip for the iPhone 15 series
• Surface-mount chip — requires hot air and micro-soldering
• For board-side Face ID faults, not a damaged dot projector
• Diagnose before fitting — replacing an IC on suspicion risks the pads

What this is used for

• Board-level Face ID repair
• Motherboard repair after liquid damage
• Replacing an IC identified by diagnosis

Who it's for

Micro-soldering technicians doing board-level Face ID repair.

Where it fits in the repair

Confirm the fault is board-side with diode-mode readings and current draw, flood the area with flux, lift the old IC with hot air, wick and level the pads, align the replacement and reflow. Test before reassembly.

Manufacturer description

The MIJING ZH01 Face ID integrated IC chip, for board-level Face ID repair across the iPhone 15 series. This is a surface-mount chip, not a plug-in flex: fitting it means lifting the original with hot air, cleaning and levelling the pads, aligning the replacement and reflowing it under magnification. What it cannot do is replace paired hardware. The dot projector is matched to the phone at the factory, so if that module is damaged or was swapped, no board-level repair restores Face ID. • Face ID integrated IC chip for the iPhone 15 series • Surface-mount chip — requires hot air and micro-soldering • For board-side Face ID faults, not a damaged dot projector • Diagnose before fitting — replacing an IC on suspicion risks the pads Compatible with: iPhone 15 series — confirm the marking on your board before ordering.